2008 International 4200 recalls and problems
The 2008 International 4200 has 3 safety recalls and 1 owner complaint filed with NHTSA. Recall repairs are free at any International dealer.
Recalls may cover only some 2008 International 4200 vehicles. Check your VIN at NHTSA ↗ to see open recalls for your exact car.
2008 International 4200 recalls
Recall 10V-267: Vehicle Speed Control
Problem: Navistar is recalling certain model year 2003 through 2010 international trucks and ic commercial buses manufactured from december 4, 2001 through december 14, 2009 equipped with international vt365 engines having engine calibration pan2pvr0, pan2pvr1, or pan2pwr. The engine normally responds to a failed open accelerator position sensor circuit fault by returning the engine to low idle speed of 800 RPM and disabling the driver's ability to increase the engine speed. However if the open circuit corrects itself within 30 seconds of initiation, engine speed could suddenly increase to a high idle speed of 1200 RPM.
Risk: This increase to high idle speed may occur without warning causing a sudden and unexpected shift in vehicle position possibly resulting in property damage, personal injury, or death.
Fix: Navistar will notify owners and dealers will repair the vehicles free of charge. The safety recall began on july 1, 2010. Owners may contact navistar at 1-800-448-7825.
Recall 10V-104: Service Brakes, Hydraulic
Problem: Navistar has notified NHTSA about a defect in certain model year 2010 and 2011 ic ce, hc, and be commercial buses and international 1300, 3200, 3300, 4100, 4200, 4300, 4400, and mxt trucks manufactured from november 19, 2003 through february 9, 2010. The parking brake may release if the brake system electronic control unit (Ecu) software misinterprets input signals generated from cycling the ignition switch more than once at a specific frequency.
Risk: Release of the parking brake may cause sudden, unexpected shift in vehicle position possibly resulting in property damage, personal damage, or death.
Fix: Navistar will notify owners and will repair the vehicles by reprogramming the vehicle's brake system ECU free of charge. The safety recall began on april 14, 2010. Owners may contact navistar at 1-260-461-1890.
Recall 07V-179: Suspension
Problem: On certain trucks, one or both rear axle housings may contain thinner material than what is necessary for normal vehicle operation. Over time, this thinner material may result in a fatigue failure of the rear axle housing, possibly in the location of the brake flange.
Risk: A crack in the brake flange location of the rear axle housing may result in a wheel end lockup or wheel separation possibly resulting in property damage, personal injury, or death.
Fix: Dealers will inspect the vehicle's rear axles and, if necessary, replace the axle housings. The recall began on may 18, 2007. Owners may contact international at 1-800-448-7815.
2008 International 4200 problems reported by owners
| Problem area | Reports | |
|---|---|---|
| Electrical System | 1 | |
| Engine | 1 |
Problems that are not covered by a recall are paid repairs; labor rates follow local mechanic pay — see what auto mechanics earn in each state.
Recent 2008 International 4200 complaints
Owner reports filed with NHTSA, as written (personal details removed). Complaints are not verified by NHTSA.
Other International 4200 years
Compare all International 4200 years · All International models
Frequently asked questions
Does the 2008 International 4200 have any recalls?
Yes — NHTSA lists 3 recalls for the 2008 International 4200: 10V-267 (vehicle speed control), 10V-104 (service brakes, hydraulic), 07V-179 (suspension). Not every vehicle is affected, so check your VIN at nhtsa.gov/recalls.
What is the most common problem with the 2008 International 4200?
Owners report electrical system problems most often (1 reports), followed by engine (1).
Are International recall repairs free?
Yes. Safety recall repairs are free at authorized International dealers, whether you are the first owner or bought the car used.